Cisco N7K-C7010 Configuration Guide - Page 48
Configuring the Error-Disabled Recovery Interval
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Configuring the Basic Interface Parameters Chapter 2 Configuring Basic Interface Parameters Send document comments to [email protected] DETAILED STEPS Step 1 Command configure terminal Purpose Enters configuration mode. Step 2 Step 3 Step 4 Example: switch# configure terminal switch(config)# errdisable recovery cause {all | bpduguard | link-flap | psecure-violation | security-violation | storm-control | udld} Example: switch(config)# errdisable recovery cause all switch(config-if)# show interface status err-disabled Example: switch(config)# show interface status err-disabled copy running-config startup-config Example: switch(config)# copy running-config startup-config Specifies a condition under which the interface automatically recovers from the error-disabled state, and the device retries bringing the interface up. The device waits 300 seconds to retry. The default is disabled. Displays information about error-disabled interfaces. (Optional) Copies the running configuration to the startup configuration. This example shows how to enable error-disabled recovery under all conditions: switch(config)# errdisable recovery cause all switch(config)# Configuring the Error-Disabled Recovery Interval You can configure the error-disabled recovery timer value. SUMMARY STEPS 1. configure terminal 2. errdisable recovery interval interval 3. show interface status err-disabled 4. copy running-config startup-config 2-24 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03