Cisco N7K-C7010 Configuration Guide - Page 182

Configuring Port Channels Chapter 6 Configuring Port Channels Send document comments to [email protected] Step 6 Command show interface port-channel channel-number Step 7 Example: switch(config-router)# show interface port-channel 2 copy running-config startup-config Example: switch(config)# copy running-config startup-config Purpose (Optional) Displays interface information for the specified port channel. (Optional) Copies the running configuration to the startup configuration. This example shows how to set port channel 2 to 100 Mb/s: switch# configure terminal switch (config)# interface port-channel 2 switch(config-if)# speed 100 Configuring Flow Control You can enable or disable the capability of the port-channel interfaces that run at 1 Gb or higher to send or receive flow-control pause packets. For port-channel interfaces that run at lower speeds, you can enable or disable only the capability of the port-channel interfaces to receive pause packets. Note The settings have to match at both the local and remote ends of the link so that flow control can work properly. SUMMARY STEPS 1. configure terminal 2. interface port-channel channel-number 3. flowcontrol {receive | send} {desired | off | on} 4. exit 5. show interface port-channel channel-number 6. copy running-config startup-config 6-26 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03