Cisco N7K-C7010 Configuration Guide - Page 53
Step 1, Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Chapter 2 Configuring Basic Interface Parameters Configuring the Basic Interface Parameters Send document comments to [email protected] DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# interface interface Example 1: switch(config)# interface ethernet 2/1 switch(config-if)# Example 2: switch(config)# interface mgmt0 switch(config-if)# Step 3 speed {{10 | 100 | 1000 | {auto [10 100 [1000]]}} | {10000 | auto}} Example: switch(config-if)# speed 1000 switch(config-if)# Step 4 duplex {full | half | auto} Step 5 Example: switch(config-if)# duplex full show interface interface Step 6 Example: switch(config)# show interface mgmt0 exit Step 7 Example: switch(config-if)# exit switch(config)# copy running-config startup-config Example: switch(config)# copy running-config startup-config Purpose Enters the global configuration mode. Specifies the interface that you are configuring. You can specify the interface type and identity. For an Ethernet port, use "ethernet slot/port." For the management interface, use "mgmt0." Example 1 shows how to specify the slot 2 port 1 Ethernet interface. Example 2 shows how to specify the management interface. For Ethernet ports on the 48-port 10/100/1000 modules, sets the speed at 10 Mb/s, 100 Mb/s, or 1000 Mb/s, or sets the port to autonegotiate its speed with the other 10/100/1000 port on the same link. For Ethernet ports on the 32-port 10-Gigabit Ethernet modules, sets the speed at 10,000 Mb/s (10 Gb/s) or sets the port to autonegotiate its speed with the other 10-Gigabit Ethernet port on the link. For management interfaces, sets the speed as 1000 Mb/s or sets the port to autonegotiate its speed. Specifies the duplex mode as full, half, or autonegotiate. Displays the interface status, which includes the speed and duplex mode parameters. Exits the interface mode. (Optional) Copies the running configuration to the startup configuration. This example shows how to set the speed of Ethernet port 1 on the 48-port 10/100/1000 module in slot 3 to 1000 Mb/s and full-duplex mode: OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 2-29