Cisco N7K-C7010 Configuration Guide - Page 290
Configuring Thresholds for Layer 2 Protocol Tunnel Ports
UPC - 882658174445
View all Cisco N7K-C7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 290 highlights
Configuring Q-in-Q Tunnels and Layer 2 Protocol Tunneling Chapter 9 Configuring Q-in-Q VLAN Tunnels Send document comments to [email protected] DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal hardware rate-limiter layer-2 l2pt packets-per-second Step 3 Example: switch(config)# hardware rate-limiter layer-2 l2pt 4096 no hardware rate-limiter layer-2 l2pt Example: switch(config)# no hardware rate-limiter layer-2 l2pt Purpose Enters global configuration mode. Sets the threshold in packets per second above which incoming protocol packets from dot1q-tunnel ports are dropped in hardware. Valid values are from 0 to 30000. (Optional) Resets the threshold values to the default of 500 packets per second. Configuring Thresholds for Layer 2 Protocol Tunnel Ports You can specify the port drop and shutdown value for a Layer 2 protocol tunneling port. SUMMARY STEPS 1. configure terminal 2. interface ethernet slot/port 3. switchport 4. switchport mode dot1q-tunnel 5. l2protocol tunnel drop-threshold [cdp | stp | vtp] packets-per-sec 6. no l2protocol tunnel drop-threshold [cdp | stp | vtp] 7. l2protocol tunnel shutdown-threshold [cdp | stp | vtp] packets-per-sec 8. no l2protocol tunnel shutdown-threshold [cdp | stp | vtp] 9. exit 10. copy running-config startup-config DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal interface ethernet slot/port Example: switch(config)# interface ethernet 7/1 Purpose Enters global configuration mode. Specifies an interface to configure, and enters interface configuration mode. 9-14 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x OL-23435-03