Cisco N7K-C7010 Configuration Guide - Page 79

Chapter 2 Configuring Basic Interface Parameters Monitoring the Interface Counters Send document comments to [email protected] SUMMARY STEPS 1. configure terminal 2. load-interval counters {{1 | 2| 3} seconds} 3. show interface interface 4. exit 5. copy running-config startup-config DETAILED STEPS Command Step 1 configure terminal Purpose Enters the configuration mode. Step 2 Step 3 Example: switch# configure terminal switch# load-interval counters {{1 | 2 | 3} seconds} Example: switch(config)# load-interval counters 1 100 switch(config)# show interface interface Sets up to three sampling intervals to collect bit-rate and packet-rate statistics. The default values for each counter is as follows: 1-30 seconds; 60 seconds for VLAN network interface 2-300 seconds 3-not configured Displays the interface status, which includes the counters. Step 4 Example: switch(config)# show interface vlan 10 switch# exit Exits the configuration mode. Step 5 Example: switch(config)# exit switch# copy running-config startup-config Example: switch# copy running-config startup-config (Optional) Copies the running configuration to the startup configuration. This example shows how to set the three sample intervals for the Ethernet port 3/1: switch# configure terminal switch(config)# interface ethernet 3/1 switch(config-if)# load-interval counter 1 60 switch(config-if)# load-interval counter 2 135 switch(config-if)# load-interval counter 3 225 switch(config-if)# OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 2-55