Cisco N7K-C7010 Configuration Guide - Page 177

Chapter 6 Configuring Port Channels Configuring Port Channels Send document comments to [email protected] Step 5 Command show interface type slot/port Step 6 Example: switch(config-router)# show interface ethernet 1/4 copy running-config startup-config Example: switch(config)# copy running-config startup-config Purpose (Optional) Displays interface information. (Optional) Copies the running configuration to the startup configuration. Use the no channel-group command to remove the port from the channel group. The port reverts to its original configuration. You must reconfigure the IP addresses for this port. Command no channel-group Example: switch(config)# no channel-group Purpose Removes the port from the channel group. This example shows how to add a Layer 3 Ethernet interface 1/5 to channel group 6 in on mode: switch# configure terminal switch (config)# interface ethernet 1/5 switch(config-if)# no switchport switch(config-if)# channel-group 6 This example shows how to create a Layer 3 port-channel interface and assign the IP address: switch# configure terminal switch(config)# interface port-channel 4 switch(config-if)# ip address 192.0.2.1/8 Configuring the Bandwidth and Delay for Informational Purposes The bandwidth of the port channel is determined by the number of total active links in the channel. You configure the bandwidth and delay on port-channel interfaces for informational purposes. SUMMARY STEPS 1. configure terminal 2. interface port-channel channel-number 3. bandwidth value 4. delay value 5. exit 6. show interface port-channel channel-number 7. copy running-config startup-config OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 6-21