Cisco N7K-C7010 Configuration Guide - Page 51

Chapter 2 Configuring Basic Interface Parameters Configuring the Basic Interface Parameters Send document comments to [email protected] SUMMARY STEPS 1. configure terminal 2. interface ethernet slot/port 3. link debounce time milliseconds 4. show interface debounce 5. exit 6. copy running-config startup-config DETAILED STEPS Step 1 Command configure terminal Step 2 Example: switch# configure terminal switch(config)# interface ethernet slot/port Step 3 Example: switch(config)# interface ethernet 3/1 switch(config-if)# link debounce time milliseconds Step 4 Example: switch(config-if)# link debounce time 1000 switch(config-if)# show interface debounce Step 5 Example: switch(config)# show interface debounce switch(config-if)# exit Step 6 Example: switch(config-if)# exit switch(config)# copy running-config startup-config Example: switch(config)# copy running-config startup-config Purpose Enters configuration mode. Specifies an interface to configure, and enters interface configuration mode. Enables the debounce timer for the amount of time (0 to 5000 ms) specified. Disables the debounce timer if you specify 0 milliseconds. Shows the link debounce time for all of the Ethernet interfaces. Exits the interface mode. (Optional) Copies the running configuration to the startup configuration. This example shows how to enable the debounce timer and set the debounce time to 1000 ms for the Ethernet port 3/1: switch# configure terminal switch(config)# interface ethernet 3/1 switch(config-if)# link debounce time 1000 switch(config-if)# This example shows how to disable the debounce timer for the Ethernet port 3/1: switch# configure terminal switch(config)# interface ethernet 3/1 OL-23435-03 Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x 2-27