Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 131

Fabric OS System Messages Chapter 5 AG Messages AG-1001 Message Message Type Severity Probable Cause Recommended Action N_Port ID virtualization (NPIV) is not supported by fabric port connected to port . LOG ERROR Indicates that the N_Port ID virtualization (NPIV) capability is not supported by the fabric port to which the Access Gateway is connected. • Execute the portCfgNpivPort command to enable NPIV capability on the port connected to the Access Gateway. • Some blades and ports in a switch may not support NPIV. NPIV functionality cannot be enabled on such ports and they will not respond to NPIV requests. Refer to the Access Gateway Administrator's Guide for specific AG-compatibility requirements. • On non-Brocade switches, refer to the manufacturer's documentation to determine whether the switch supports NPIV and how to enable NPIV on these types of switches. AG-1002 Message Message Type Severity Probable Cause Recommended Action Unable to find alternate N_Port during failover for N_Port . LOG WARNING Indicates that no other N_Port is configured or the fabric was unstable during failover. Check whether an alternate N_Port is configured using the portCfgShow command. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Brocade Fabric OS Message Reference 113 53-1004119-01