Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 829

ZONE-1002 5 ZONE Messages ZONE-1002 Message Message Type Severity Probable Cause Recommended Action WWN zoneTypeCheck or zoneGroupCheck warning() at port(). LOG WARNING Indicates that a zone filter or zone group check failure occurred. The frame filter logic reported a failure when creating or adding the zone groups during port login (PLOGI) trap processing. This message usually indicates problems when adding the content-addressable memory (CAM) entries before the filter setup. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. ZONE-1003 Message Message Type Severity Probable Cause Recommended Action zone() contains (, ) which does not exist. LOG WARNING Indicates that the port zone member that is targeted for the local switch contains a nonexistent port. The specified port number in the effective zoning configuration (displayed in the error message) is out of range. Edit the zone database and change the port number to a viable value in the effective configuration. ZONE-1004 Message Message Type Severity Probable Cause Base PID: 0x, Port Index: , Port: : enforcement changed to Session-based HARD Zoning. LOG INFO Indicates that the zoning enforcement has changed to session-based hard zoning due to one of the following conditions: • The zone has a mix of WWN and domain,index (D,I) members. • The Source Identifier (S_ID) list of the hardware-enforced zoning exceeded the S_ID limit. Brocade Fabric OS Message Reference 811 53-1004119-01