Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 294

5 EM-1061 EM-1061 Message Message Type Severity Probable Cause Recommended Action Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. LOG WARNING Indicates that the blade in the system is not supported by the firmware on the standby control processor (CP). Remove all blades of the specified type or upgrade the standby CP. After an appropriate action is taken, restart the standby CP or execute the haSyncStart command to enable the high availability (HA) state synchronization. Until this is done, the system will remain out of synchronization. EM-1062 Message Message Type Severity Probable Cause Recommended Action Blade in slot faulted as it exceeds the maximum support limit of blades with Blade ID in the chassis. LOG CRITICAL Indicates that too many blades of a particular type are in the system. Remove the faulted blade. EM-1063 Message Message Type Severity Probable Cause Recommended Action Blade in slot faulted because it exceeds the maximum support limit of blades with Blade IDs in the chassis. LOG CRITICAL Indicates that too many blades of a set of particular types are in the system. Remove the faulted blade. 276 Brocade Fabric OS Message Reference 53-1004119-01