Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 593

PLAT-1009 5 PLAT-1009 Message Message Type Severity Probable Cause Recommended Action BladeSystem Chassis type requires setting maximum internal port speed to 8Gbps. LOG WARNING Indicates that the chassis has an older midplane that cannot support 16 GFC internal ports. This message occurs only on the Brocade 6548. Install the switch in a newer chassis. PLAT-1010 Message Message Type Severity Probable Cause Recommended Action SPDC HOST Initi failed spdc_status 0x, rdy0=0x, rdy1=0x fen=0x, hk_fen=0x, ocp=0x. LOG | FFDC CRITICAL Indicates that the Serial Private Data Channel (SPDC) host hardware encountered an unrecoverable error. Upgrade the control processor (CP) to the latest field-programmable gate array (FPGA) version, or replace the CP blade. PLAT-1072 Message Message Type Severity Probable Cause Recommended Action The chassis is disabled because no Core Blades are available. Insert/replace one or both Core Blades and run chassisenable. FFDC | LOG CRITICAL Indicates that the chassis has been disabled because of the unavailability of the core blades. There must be at least one core blade in enabled state for the chassis to be considered ready. All core blades are either missing, faulted, or powered off. This results in all logical switches (and ports) being disabled. Make sure that all core blade slots have core blades inserted and their ejector switches are closed. Power on core blades that are powered off, and power cycle or replace the core blades that are faulted. Run the chassisenable command to re-enable the ports. Running the fastboot or reboot command will also result in enabling the logical switches and ports. Brocade Fabric OS Message Reference 575 53-1004119-01