Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 795

TRCE-1007 5 TRCE-1007 Message Message Type Severity Probable Cause Recommended Action Notification of this CP has failed. Parameters temporarily out of sync with other CP. LOG ERROR Indicates that the active control processor (CP) is unable to alert the standby CP of a change in trace status. This message is only applicable to bladed switches. This message is often transitory. Wait a few minutes and try the command again. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. TRCE-1008 Message Message Type Severity Probable Cause Recommended Action Unable to load trace parameters. FFDC | LOG CRITICAL Indicates that the active control processor (CP) is unable to read the stored trace parameters. Reboot the CP (dual-CP system) or restart the switch. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. TRCE-1009 Message Message Type Severity Probable Cause Recommended Action Unable to alert active CP that a dump has occurred. LOG WARNING Indicates that the control processor (CP) is unable to communicate trace information to active CP. This message is only applicable to bladed switches. Execute the haShow command to verify that the current management module is standby and the active management module is active. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Brocade Fabric OS Message Reference 777 53-1004119-01