Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 784

5 SWCH-1022 SWCH-1022 Message Message Type Severity Probable Cause Recommended Action Port: has been disabled due to port address conflict while enabling FMS mode. LOG WARNING Indicates that the switch has ports with FICON Management Server (FMS) reserved areas (0xFE, 0xFF) that are not supported in FMS mode. No action required. Refer to the FICON Administrator's Guide for more information. SWCH-1023 Message Message Type Severity Probable Cause Recommended Action HA state out of sync: Standby CP (ver = ) does not support XISL use while fmsmode and/or lossless are enabled (Active CP version =). LOG WARNING Indicates that the standby control processor (CP) does not support extended inter-switch link (XISL) while FICON Management Server (FMS) mode and Lossless are enabled. Load a firmware version on standby CP that supports both XISL use and FMS mode and Lossless at the same time by using the firmwareDownload command. SWCH-1024 Message Message Type Severity Probable Cause Recommended Action HA state out of sync: Standby CP (ver = ) does not support active's enforce_login policy (Active CP version =). LOG WARNING Indicates that the standby control processor (CP) does not enforce login policy of the active CP. Configure the enforce login policy to a value that the standby CP supports. 766 Brocade Fabric OS Message Reference 53-1004119-01