Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 174

5 BL-1007 BL-1007 Message Message Type Severity Probable Cause Recommended Action blade #: blade state is inconsistent with EM. bl_cflags 0x, slot_on , slot_off , faulty , status . LOG WARNING Indicates that a failover occurred while a blade was initializing on the previously active control processor (CP). No action is required. The blade is reinitialized. Because reinitializing a blade is a disruptive operation and can stop I/O traffic, you may need to stop and restart the traffic during this process. BL-1008 Message Message Type Severity Probable Cause Recommended Action Slot control-plane failure. Expected value: 0x, Actual: 0x. FFDC | LOG CRITICAL Indicates that the blade has experienced a hardware failure or was removed without following the recommended removal procedure. Make sure that the blade is seated correctly. If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1009 Message Message Type Severity Probable Cause Blade in slot timed out initializing the chips. FFDC | LOG CRITICAL Indicates that the blade has failed to initialize the application-specific integrated circuit (ASIC) chips. 156 Brocade Fabric OS Message Reference 53-1004119-01