Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 35

Configuring system messages and attributes 1 The following example displays the documentation for PS-1007. switch:admin> rasman PS-1007 Log Messages PS-1007(7m) MESSAGE PS-1007 - Failed to add Fabricmode Top Talker on domain=. . MESSAGE TYPE LOG SEVERITY WARNING PROBABLE CAUSE Indicates that FC Routing (FCR) is enabled on the specified fabric. RECOMMENDED ACTION Top Talker cannot be installed on a fabric with FCR service enabled. In case Top Talker must be installed on a fabric, disable FCR using the fosconfig --disable fcr command. Configuring system messages and attributes This section provides information on configuring the system message logs and its attributes. All admin-level commands mentioned in this section are used to enable or disable only the external messages. Configuring event auditing To configure event auditing, perform the following steps. 1. Log in to the switch as admin. 2. Enter the auditCfg --enable command to enable the audit feature. switch:admin> auditcfg --enable Audit filter is enabled. 3. Enter the auditCfg --class command to configure the event classes you want to audit. switch:admin> auditcfg --class 1,2,3,4,5,6,7,8,9 Audit filter is configured. NOTE The RAS audit class is not configurable, and it is always enabled internally. 4. Use the auditCfg --severity severity level command if you want to set the audit severity level. By default, all messages are logged. When the severity is set, only messages with the configured severity and higher are displayed. Valid values for severity level are INFO, WARNING, ERROR, and CRITICAL switch:admin> auditcfg --severity ERROR 5. Enter the auditCfg --show command to verify the configuration. switch:admin> auditcfg --show Brocade Fabric OS Message Reference 15 53-1004119-01