Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 42

1 Clearing the system message logs Clearing the system message logs This section provides information on clearing the system message logs. These procedures are valid for all the supported platforms. Clearing the system message log To clear the system message log for a particular switch instance, perform the following steps. 1. Log in to the switch as admin. 2. Enter the errClear command to clear all messages from memory. NOTE For products that have a single processor, all error log messages are cleared. For products that have multiple processors, this command only clears the error logs of the processor from which it is executed. Clearing the audit message log To clear the audit message log for a particular switch instance, perform the following steps. 1. Log in to the switch as admin. 2. Enter the auditDump -c command to clear all audit messages from memory. Reading the system messages This section provides information about reading the RASLog and audit messages. Reading a RAS system message This section provides information about reading system messages. The following example shows the format of a RAS system error message. , [], , , , , The following example shows a sample message from the error log. 2011/02/10-14:18:04, [SS-1000], 88, SLOT 6 | FFDC | CHASSIS, INFO, ESNSVT_DCX, supportSave has uploaded support information to the host with IP address 192.0.2.2. 2011/02/10-14:13:34, [SS-1001], 87, SLOT 6/1 | FFDC | CHASSIS, WARNING, ESNSVT_DCX, supportSave's upload operation to host IP address aborted. 2011/02/10-15:44:51, [SEC-1203], 89, SLOT 6 | FFDC | FID 128, INFO, ESNSVT_DCX, Login information: Login successful via TELNET/SSH/RSH. IP Addr:192.0.2.2. 22 Brocade Fabric OS Message Reference 53-1004119-01