Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 646

5 SEC-1075 SEC-1075 Message Message Type Severity Probable Cause Recommended Action Fail to new policy set on all switches. LOG ERROR Indicates a corruption occurred during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) distributes the security database to the other switches in the fabric, and then local validation finds the error in the security database. This is a rare occurrence. Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database may not be correctly updated for that specific switch. SEC-1076 Message Message Type Severity Probable Cause Recommended Action NoNodeWWNZoning option has been changed. LOG ERROR Indicates the NoNodeWWNZoning option has been changed. If the option is turned on, a zone member can be added using node WWNs, but the member will not be able to communicate with others nodes in the zone. Re-enable the current zone configuration for the change to take effect. SEC-1077 Message Message Type Severity Probable Cause Recommended Action Failed to activate new policy set on all switches. LOG ERROR Indicates the policy could not be activated. Possible reasons that the policy could not be activated include not enough memory or a busy switch. Run the secFabricShow command to verify that all switches in the fabric are in the ready state. Retry the command when all switches are ready. 628 Brocade Fabric OS Message Reference 53-1004119-01