Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 293

EM-1058 5 EM-1058 Message Message Type Severity Probable Cause Recommended Action Switch gets reset:. LOG WARNING Indicates that the switch is being automatically reset because of a known resetable transient problem such as an application-specific integrated circuit (ASIC) parity error. No action is required if the switch does not reach the reset threshold for the switch or blade. If the reset threshold is reached on the switch or blade, the switch or blade will be faulted and should be replaced. EM-1059 Message Message Type Severity Probable Cause Recommended Action with ID may not be supported on this platform, check FOS firmware version as a possible cause. LOG ERROR Indicates that a a blade inserted in the specified slot or the switch (for non-bladed switches) is incompatible with the switch configuration software. The blade will not be completely usable. The blade may only be supported by a later (or earlier) version of the firmware. Change the control processor (CP) firmware or replace the blade. Make sure the replacement is compatible with your switch type and firmware. EM-1060 Message Message Type Severity Probable Cause Recommended Action Stopping synchronization of the system due to blade incompatibility with software version on standby CP. LOG WARNING Indicates that a blade in the system is not supported by the firmware on the standby control processor (CP). Remove all blades of this type or upgrade the standby CP. After an appropriate action is taken, restart the standby CP or execute the haSyncStart command to enable the high availability (HA) state synchronization. Until this is done, the system will remain out of synchronization. Brocade Fabric OS Message Reference 275 53-1004119-01