Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 40

1 Displaying system message logs and attributes Message Status Default Severity Current Severity ECC-1000 ENABLED ERROR ERROR ECC-1001 DISABLED ERROR WARNING • Enter the rasadmin --show -disabled command to list all disabled RASLog messages. switch:admin> rasadmin --show -disabled Message Status CDR-1001 : DISABLED CDR-1003 : DISABLED CDR-1004 : DISABLED ECC-1001 : DISABLED IPAD-1002 : DISABLED Displaying the severity level of RASLog messages To display the severity level of a RASLog message, perform the following steps. 1. Log in to the switch as admin. 2. Use the rasadmin --show -severity message_ID command to display the severity level of a RASLog message. The following example displays the status of the SEC-1203 message. switch:admin> rasadmin --show -severity SEC-1203 Message Severity SEC-1203 : WARNING Displaying RASLog messages by severity level To display the RASLog messages based on the severity level, perform the following steps. 1. Log in to the switch as admin. 2. Use the errdump --severity [DEFAULT | INFO | WARNING | ERROR | CRITICAL] command. For more information on message severity levels, refer to "Message severity levels" on page 3. You can set the count of messages to display using the count option. The following example filters messages by severity level of ERROR. switch:admin> errdump --count 4 --severity ERROR Fabric OS: 8.0.1 2012/10/24-11:23:24, [C3-1001], 12, CHASSIS, ERROR, switch, Port 4 failed due to SFP validation failure. Check if the SFP is valid for the configuration. 2012/10/24-11:23:24, [C3-1001], 13, CHASSIS, ERROR, switch, Port 5 failed due to SFP validation failure. Check if the SFP is valid for the configuration. 2012/10/24-11:23:25, [C3-1001], 14, CHASSIS, ERROR, switch, Port 18 failed due to SFP validation failure. Check if the SFP is valid for the configuration. 2012/10/24-11:46:14, [C3-1001], 27, CHASSIS, ERROR, switch, Port 4 failed due to SFP validation failure. Check if the SFP is valid for the configuration. Displaying RASLog messages by message ID To display the RASLog messages based on the message ID, perform the following steps. 20 Brocade Fabric OS Message Reference 53-1004119-01