Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 482

5 HIL-1514 HIL-1514 Message Message Type Severity Probable Cause Recommended Action Blade in slot is shutting down. FFDC | LOG CRITICAL Indicates that the temperature of this blade has been above the maximum threshold for at least two minutes. The blade is shut down to prevent damage. This usually follows a high-temperature warning message. Run the fanShow command to verify all the fans are working properly. Make sure that the area is well-ventilated and that the room temperature is within the operational range of your switch. Refer to the hardware reference manual for your switch for the operational temperature range. If the message persists, replace the faulty blade. HIL-1515 Message Message Type Severity Probable Cause Recommended Action High temperature ( C) exceeds system temperature limit. System will shut down soon. FFDC | LOG CRITICAL Indicates that temperatures in the system have risen above the critical threshold. Run the fanShow command to verify that all fans are working properly. Replace any deteriorating fan field-replaceable units (FRUs). Make sure that the area is well-ventilated and that the room temperature is within the operational range of your switch. Refer to the hardware reference manual for your switch for the operational temperature range. HIL-1601 Message Message Type Severity Probable Cause Recommended Action Using backup temperature sensor. Attention needed. LOG ERROR Indicates that temperature readings from the primary sensor are out of range. Run the fanShow command to verify that all fans are operating correctly. Replace any deteriorating fan field-replaceable units (FRUs). Run the tempShow command to verify temperature values. If any sensor is too high, monitor the switch. Try rebooting or power cycling the switch. 464 Brocade Fabric OS Message Reference 53-1004119-01