Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 383

FCR-1097 5 FCR-1097 Message Message Type Severity Probable Cause Recommended Action Failed to get for message: port , retval . LOG ERROR Indicates that the authentication process failed to get a particular authentication value at certain phase. Data type is the payload or structure that failed to get memory. Usually this problem is transient. The authentication may fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. FCR-1098 Message Message Type Severity Probable Cause Recommended Action Invalid message code for message: port . LOG ERROR Indicates the receiving payload does not have valid message code for a particular authentication phase. Usually this problem is transient. The authentication may fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. FCR-1099 Message Message Type Severity Probable Cause Recommended Action HA sync lost as remote CP does not support Inter Chassis Link EX_Ports. LOG ERROR Indicates that the remote control processor (CP) has older firmware that does not support inter-chassis link (ICL) EX_Ports. This is causing loss of the high availability (HA) synchronization. Disable EX_Ports on ICL links or upgrade the firmware on remote CP to v7.2.0 or later. Brocade Fabric OS Message Reference 365 53-1004119-01