Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 557

MS-1009 5 MS-1009 Message Message Type Severity Probable Cause Recommended Action RLIR event. Slot/Port / (0x). Device Port Tag is 0x. . LOG ERROR Indicates a registered link incident record (RLIR) has been generated for one of the actions indicated by the message value. The message value can be one of the following: • Exceeded bit error rate threshold • Loss of signal or synchronization • Not operational seq recognized • Primitive sequence timeout • Unrecognized link incident Persistent RLIR incidents are likely the result of SAN hardware problems such as bad cables or small form-factor pluggable (SFP) transceivers. If the message persists, replace hardware. MS-1021 Message Message Type Severity Probable Cause Recommended Action MS WARMBOOT failure(FSS_MS_WARMINIT failed. Reason=). LOG ERROR Indicates that the Fabric OS state synchronization (FSS) warm recovery failed during the WARM INIT phase of a reboot. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. MS-1022 Message Message Type Severity Probable Cause Recommended Action Management Server Platform Service . LOG INFO Indicates that the Management Server (MS) platform service is being activated or deactivated. No action is required. Brocade Fabric OS Message Reference 539 53-1004119-01