Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 774

5 SULB-1050 SULB-1050 Message Message Type Class Severity Probable Cause Recommended Action Firmwaredownload command continues. AUDIT | LOG FIRMWARE INFO Indicates that the firmwareDownload command is running on the standby control processor (CP) of the dual-CP system. This process should take approximately 17 minutes. The process is set to time out after 30 minutes. Do not fail over or power down the system during firmware upgrade. Allow the firmwareDownload command to continue without disruption. No action is required. Run the firmwareDownloadStatus command for more information. SULB-1051 Message Message Type Class Severity Probable Cause Recommended Action Detected hot-plug of Standby CP. Firmware from Active CP will automatically be synchronized to Standby CP. AUDIT | LOG FIRMWARE INFO Indicates that auto firmware synchronization has started because the standby control processor (CP) is hot-plugged. No action is required. Firmware download has started on the standby CP. SULB-1052 Message Message Type Class Severity Probable Cause Recommended Action Firmwaresync has failed. AUDIT | LOG FIRMWARE ERROR Indicated that auto firmware synchronization has failed. Execute the firmwareDownloadStatus and firmwareShow commands to view firmware status. Execute the haShow command to view the HA state. 756 Brocade Fabric OS Message Reference 53-1004119-01