Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 772

5 SULB-1039 SULB-1039 Message Message Type Class Severity Probable Cause Recommended Action CP has completed relocating the internal firmware image. AUDIT | LOG FIRMWARE INFO Indicates that the firmware download process has completed normally on the control processor (CP). Run the firmwareShow command to verify the firmware versions. SULB-1040 Message Message Type Class Severity Probable Cause Recommended Action An error has occurred during relocation of the internal image on the CP. AUDIT | LOG FIRMWARE WARNING Indicates that an error has occurred during the relocation of the internal image. The error may be caused by an inconsistent internal firmware image. It may also be caused by an internal Ethernet failure. Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload command again if the firmware is not updated. This will cause the internal image to be relocated again. If the problem persists, contact your switch service provider. SULB-1041 Message Message Type Class Severity Probable Cause Recommended Action Firmware has been activated successfully on standby CP. AUDIT | LOG FIRMWARE INFO Indicates that the firmwareActivate command has completed successfully on the standby control processor (CP). No action is required. The firmwareActivate command has completed on the standby CP as expected. Run the firmwareShow command to verify the firmware versions. 754 Brocade Fabric OS Message Reference 53-1004119-01