Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 463

HAM-1007 5 Recommended Action The standby CP will take over and reset the active CP. The system will be non-redundant because the standby CP becomes the active CP. HAM-1007 Message Message Type Severity Probable Cause Recommended Action Need to reboot the system for recovery, reason: . FFDC | LOG CRITICAL Indicates that the switch in current condition needs to be restarted to achieve a reliable recovery. The reasons can be one of the following: • The standby CP was not ready when failover occurred. • The failover occurred when the last logical switch (LS) transaction was incomplete. • The switch failed when timeout occurred at certain stage. • The cold or warm recovery has failed. If auto-reboot is enabled, the switch will automatically restart. Otherwise, execute the reboot command to manually restart the switch. HAM-1008 Message Message Type Severity Probable Cause Recommended Action Rebooting the system for recovery - auto-reboot is enabled. FFDC | LOG CRITICAL Indicates that the recovery by auto-reboot is enabled, and therefore the switch automatically restarts. This message is displayed if the event logged in HAM-1007 has occurred and auto-reboot is enabled. Wait until the switch is up to perform any operations. HAM-1009 Message Message Type Severity Probable Cause Recommended Action Need to MANUALLY REBOOT the system for recovery - auto-reboot is disabled. FFDC | LOG CRITICAL Indicates that the recovery by auto-restart is disabled, therefore the switch needs to be manually restarted for recovery. This message is displayed if the event logged in HAM-1007 has occurred and auto-reboot is disabled. Execute the reboot command to restart the switch manually. Brocade Fabric OS Message Reference 445 53-1004119-01