Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 666

5 SEC-1157 SEC-1157 Message Message Type Severity Probable Cause Recommended Action PID Change failed: . LOG INFO Indicates the provisioning resources for a security policy failed because of low memory or internal error. The status values can be defined, active, or both. A negative value means that a policy set was failed by the daemon. Retry the failed command. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. SEC-1158 Message Message Type Severity Probable Cause Recommended Action Invalid name . LOG INFO Indicates the specified name is invalid. The name can be a policy name or a switch name. Enter a valid name. SEC-1159 Message Message Type Severity Probable Cause Recommended Action Non_Reachable domain . LOG INFO Indicates a corruption occurred during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) distributes the security database to the other switches in the fabric, and then local validation finds the error in the security database. This is a rare occurrence. Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database may not be correctly updated for that specific switch. 648 Brocade Fabric OS Message Reference 53-1004119-01