Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 166

5 AUTH-1048 AUTH-1048 Message Message Type Class Severity Probable Cause Recommended Action Stopping synchronization of the system due to incompatibility with standby CP. AUDIT | LOG SECURITY ERROR Indicates that the software version on the standby control processor (CP) is incompatible with this software feature enabled in this Fabric OS firmware version because the in-flight encryption feature supports both DH-CHAP and FCAP protocols. Upgrade the software on the standby CP or disable the software feature on this CP. To allow standby synchronization, use the DH-CHAP protocol only for in-flight encryption and disable FCAP protocol in authutil. Use the authutil --set -a "protocol type" command to configure the DH-CHAP protocol. AUTH-1049 Message Message Type Severity Probable Cause Recommended Action Slave port has been disabled, as Master port was disabled because of authentication failure/rejection. LOG ERROR Indicates that the specified slave port has been disabled because it received an authentication-reject response from the connected switch or device. The error informs that the slave port is disabled due to master port authentication failure or rejection. Check the connection port for a possible security attack. Check the shared secrets using the secAuthSecret command or check certificates using the secCertUtil command, and reinitialize authentication using the authutil --authinit command. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. 148 Brocade Fabric OS Message Reference 53-1004119-01