Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 770

5 SULB-1032 SULB-1032 Message Message Type Class Severity Probable Cause Recommended Action Relocating an internal firmware image on the CP. AUDIT | LOG FIRMWARE WARNING Indicates that the switch has started firmware download to the co-CPU. Wait for the operation to complete. SULB-1033 Message Message Type Class Severity Probable Cause Recommended Action Switch has completed relocating the internal firmware image. AUDIT | LOG FIRMWARE WARNING Indicates that the firmware download process has completed normally on the switch. Run the firmwareShow command to verify the firmware versions. Run the switchShow command to make sure the switch is enabled. SULB-1034 Message Message Type Class Severity Probable Cause Recommended Action Relocation of internal image timed out. AUDIT | LOG FIRMWARE ERROR Indicates that there may be an error caused by the switch initialization issue after the internal image is relocated. It may also be caused by an internal Ethernet issue or by a persistent storage hardware failure. Reboot the switch. This will cause the internal image to be relocated again. Use the firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your switch service provider. 752 Brocade Fabric OS Message Reference 53-1004119-01