Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 785

SWCH-1025 5 SWCH-1025 Message Message Type Severity Probable Cause Recommended Action This Logical Switch has ports other than 16 Gbps-capable FC ports. Edge Hold Time for these ports is unchanged and is . LOG WARNING Indicates that the edge hold time for the non 16 Gbps-capable FC ports is not the same as 16 Gbps-capable FC ports in the logical switch. The non 16 Gbps-capable FC ports use the edge hold time configured on the default switch. To know the edge hold time configured for non 16 Gbps-capable FC ports, go to the default switch and execute the configShow command. SWCH-1026 Message Message Type Severity Probable Cause Recommended Action HA state out of sync: Standby CP (ver = ) does not support auto csctl_mode (Active CP version = ). LOG WARNING Indicates that the standby control processor (CP) does not support auto class-specific control (CS_CTL) mode. Upgrade the standby CP firmware version to same level as active CP. SWCH-1027 Message Message Type Severity Probable Cause Recommended Action HA state out of sync: Standby CP (ver = ) does not support NPIV Base device Logout functionality. (active ver = ). LOG WARNING Indicates that the standby control processor (CP) does not support N_Port ID Virtualization (NPIV) base device logout functionality, but the switch has some ports with base device configured. Load a firmware version on standby CP that supports NPIV Base device Logout functionality using the firmwareDownload command, or change the 'base logout' feature with the portCfgNPIVPort command. Brocade Fabric OS Message Reference 767 53-1004119-01