Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 768

5 SULB-1024 Recommended Action The firmwareCommit command will be started automatically after the blade boots up to repair the secondary partition. If at the end of the firmware commit, the blade firmware version is still inconsistent with the active CP firmware, firmware download will be restarted automatically on the blade. Run the firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your switch service provider. SULB-1024 Message Message Type Class Severity Probable Cause Recommended Action Firmware commit has completed on the blade in slot . AUDIT | LOG FIRMWARE WARNING Indicates that the firmwareCommit command has completed on the specified blade. Run the firmwareShow command to verify the firmware versions. If the blade firmware is the same as the active CP firmware, the firmwareDownload command has completed successfully on the blade. However, if the firmware commit operation has been started to repair the secondary partition, at the end of the firmware commit, the blade firmware version may still be inconsistent with the active CP firmware. In this case, firmware download will automatically be restarted on the blade. Run the firmwareDownloadStatus command to monitor the progress. SULB-1025 Message Message Type Severity Probable Cause Recommended Action The blade in slot will reboot with the new firmware. LOG WARNING Indicates that new firmware has been downloaded to the specified application processor (AP) blade and the AP blade will reboot to activate it. Wait for the blade to reboot. 750 Brocade Fabric OS Message Reference 53-1004119-01