Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 173

BL-1003 5 BL-1003 Message Message Type Severity Probable Cause Recommended Action Faulting blade in slot . FFDC | LOG CRITICAL Indicates a faulty blade in the specified slot. Make sure that the blade is seated correctly. If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1004 Message Message Type Severity Probable Cause Recommended Action Suppressing blade fault in slot . FFDC | LOG CRITICAL Indicates that the specified blade experienced a failure but was not faulted due to a user setting. Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1006 Message Message Type Severity Probable Cause Recommended Action Blade NOT faulted. Peer blade experienced abrupt failure. LOG INFO Indicates that the errors (mostly synchronization errors) on the specified blade are harmless. Probably, the standby control processor (CP) blade connected to the active CP blade has experienced transitory problems. Execute the haShow command to verify that the standby CP is healthy. If the problem persists, remove and reinstall the faulty blade. If the standby CP was removed or faulted by user intervention, no action is required. Brocade Fabric OS Message Reference 155 53-1004119-01