Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 298

5 EM-1073 EM-1073 Message Message Type Severity Probable Cause Recommended Action Blade devices cannot be accessed. The blade in slot is being moved to ABSENT state. FFDC | LOG CRITICAL Indicates that the devices on the blade were not accessible. Blade is being tranisitioned to the ABSENT state. Reseat or replace the affected blade. EM-1074 Message Message Type Severity Probable Cause Recommended Action The ASIC in is overheating: Shutting down. FFDC | LOG CRITICAL Indicates that the ASIC present in switch is overheating and is beyond thermal operating range. This event is typically due to a faulty fan and can also be caused by the switch environment. Verify that the location temperature is within the operational range of the switch. Refer to the Hardware Reference Manual for the environmental temperature range of your switch. Execute the fanShow command to verify that all fans are running at normal speeds. If any fans are missing or not performing at high enough speed, they should be replaced. EM-1134 Message Message Type Severity Probable Cause Recommended Action set to faulty, rc=. LOG | FFDC ERROR Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified reason. Reseat the FRU. Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade by using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the problem persists, replace the FRU. 280 Brocade Fabric OS Message Reference 53-1004119-01