Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 139

AG-1024 5 AG-1024 Message Message Type Severity Probable Cause Recommended Action F_Port is failed back to its preferred N_Port . LOG INFO Indicates that the specified N_Port is failing back F_Ports, which are failed over to some other N_Port. Execute the ag --mapshow command to display the updated F_Port-to-N_Port mapping. AG-1025 Message Message Type Severity Probable Cause Recommended Action Port group of Slave N_Port is different than its Master N_Port . LOG ERROR Indicates that the port groups of the Master and Slave N_Ports are different, while the trunk area assigned to the attached F_Ports on the edge switch is the same. Execute the porttrunkarea --show command on the attached switch to verify that the trunk area is assigned to all ports in the system, and execute the porttrunkarea --enable command to reconfigure the trunk area. AG-1026 Message Message Type Severity Probable Cause Recommended Action Unable to handle the login request on port due to insufficient resources. LOG WARNING Indicates that there are insufficient resources to accept the login request. Execute the configure command on the Access Gateway switch and increase the number of allowed logins on the specified port. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Brocade Fabric OS Message Reference 121 53-1004119-01