Dell Brocade G620 Brocade 8.0.1 Fabric OS Message Reference Guide - Page 176

5 BL-1012 BL-1012 Message Message Type Severity Probable Cause Recommended Action bport port int. is disabled. status=0x Port will be re-enabled in 1 minute. LOG ERROR Indicates that the port generated an excessive number of interrupts that may prove unrecoverable to the switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport is the blade port; this number may not correspond to a user port number. Make sure to capture the console output during this process. Check for a faulty cable, small form-factor pluggable (SFP) transceiver, or device attached to the specified port. On a bladed switch, run the slotPowerOff and slotPowerOn commands to power cycle the blade. On a non-bladed switch, reboot or power cycle the switch. If the message persists, replace the blade or the (non-bladed) switch. BL-1013 Message Message Type Severity Probable Cause Recommended Action bport port is faulted. status=0x Port will be re-enabled in 1 minute. LOG ERROR Indicates that the port generated an excessive number of interrupts that may prove fatal to the switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport number displayed in the message is the blade port; this number may not correspond to a user port number. Make sure to capture the console output during this process. Check for a faulty cable, small form-factor pluggable (SFP) transceiver, or device attached to the specified port. On a bladed switch, run the slotPowerOff and slotPowerOn commands to power cycle the blade. On a non-bladed switch, reboot or power cycle the switch. If the message persists, replace the blade. 158 Brocade Fabric OS Message Reference 53-1004119-01