Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 126
Installing the System Fan, Install the expansion card shroud. See Installing the Expansion Card
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Installing the System Fan CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the system and protecting against electrostatic discharge. 1 Hold the replacement fan with the fan cable on the left side (opposite of the power supply), and align the edges of the fan with the securing slots. 2 Slide the fan left into the securing slots until the fan release tab locks into place. See Figure 3-32. 3 Connect the cable to the FAN_2 connector on the system board (see Figure 6-1 for the connector location). 4 Install the processor shroud. See "Installing the Processor Shroud" on page 74. 5 Install the expansion card shroud. See "Installing the Expansion Card Shroud" on page 75. 6 Close the system. See "Closing the System" on page 70. 7 Place the system upright and on its feet on a flat, stable surface. 8 Reattach any peripherals, then connect the system to the electrical outlet. 9 Turn on the system and attached peripherals. 126 Installing System Components