Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 40

Table 1-6. System Messages (continued) Message Causes Corrective Actions Unsupported CPU combination Unsupported CPU stepping detected Microprocessor(s) is not supported by the system. Install a supported microprocessor or microprocessor combination (see "Processors" on page 133). Utility partition not available The key was pressed during POST, but no utility partition exists on the boot hard drive. Create a utility partition on the boot hard drive (see the CDs that came with your system). Warning: A fatal A fatal system error occurred Check the SEL for error has caused and caused the system to information that was logged system reset! restart. during the error. See the Please check the applicable troubleshooting system event log! section in "Troubleshooting Your System" on page 159 for any faulty components specified in the SEL. Warning! No micro Micro code update failed. code update loaded for processor n Update the BIOS firmware (see "Getting Help" on page 205). Warning: The installed memory configuration is not optimal. For more information on valid memory configurations, please see the system documentation on support.dell.com Invalid memory configuration. Ensure that the memory modules are installed in a valid configuration (see "General Memory Module Installation Guidelines" on page 127). If the problem persists, see "Troubleshooting System Memory" on page 174. 40 About Your System