Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 155
SAS/SATA Backplane on Remove the system board from the chassis. See
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
NOTICE: To prevent damaging the processor, do not pry the heat sink off of the processor. 12 Remove the processor(s). See "Removing a Processor" on page 133. 13 If applicable, remove the SAS/SATA backplane. See "Removing the SAS/SATA Backplane" on page 148. 14 Carefully route any loose cables away from the edges of the system board. 15 Remove the system board from the chassis. See Figure 3-44. a Pull and hold the blue system board release pin. b While holding the release pin and the system board touch point, slide the system board towards the front of the system, and lift the board out of the chassis. Figure 3-44. Removing and Installing the System Board 2 3 1 1 system board release pin 3 system board touch point 4 2 system board 4 system board securing slots Installing System Components 155