Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 147
Installing the Power Supply Distribution Board
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
b Install a non-redundant power supply. See "Installing a Non-redundant Power Supply" on page 81. Figure 3-41. Removing and Installing the Power Supply Cage Cover 3 4 2 1 1 power supply cage cover 3 release pin alignment holes (2) 2 release pins (2) 4 power supply cage Installing the Power Supply Distribution Board 1 If present, remove the power supply cage cover. Pull the blue release pins until the cover is free from the alignment holes, and lift the cover out of the chassis. See Figure 3-41. 2 Position the power supply distribution board so that the securing tabs on the chassis are fully inserted into the securing slots on the board. See Figure 3-40. Installing System Components 147
Installing System Components
147
b
Install a non-redundant power supply. See "Installing a Non-redundant
Power Supply" on page 81.
Figure 3-41.
Removing and Installing the Power Supply Cage Cover
Installing the Power Supply Distribution Board
1
If present, remove the power supply cage cover.
Pull the blue release pins until the cover is free from the alignment holes,
and lift the cover out of the chassis. See Figure 3-41.
2
Position the power supply distribution board so that the securing tabs on
the chassis are fully inserted into the securing slots on the board. See
Figure 3-40.
1
power supply cage cover
2
release pins (2)
3
release pin alignment holes (2)
4
power supply cage
1
3
2
4