Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 39

pending. Press I, Check the Time and Date

Page 39 highlights

Table 1-6. System Messages (continued) Message Causes Corrective Actions This system supports only Opteron(TM) 2000 series processors Microprocessor(s) is not supported by the system. Install a supported microprocessor or microprocessor combination (see "Installing a Processor" on page 136). Time-of-day clock stopped Faulty battery or faulty chip. See "Troubleshooting the System Battery" on page 170. Time-of-day not Incorrect Time or Date set - please run settings; faulty system SETUP program battery. Check the Time and Date settings (see "Entering the System Setup Program" on page 43). If the problem persists, replace the system battery (see "System Battery" on page 138). Timer chip Faulty system board. counter 2 failed See "Getting Help" on page 205. TPM configuration operation honored System will now restart. Information only. TPM failure A Trusted Platform Module See "Getting Help" on (TPM) function has failed. page 205. TPM operation is Configuration change has pending. Press I been requested. to Ignore or M to Modify to allow this change and reset the system. Press I to continue system boot. Press M to modify the TPM setting and restart. Unexpected interrupt in protected mode DIMMs are improperly Reseat the DIMMs (see seated or the keyboard/mouse "Troubleshooting System controller chip has failed. Memory" on page 174). If the problem persists, see "Getting Help" on page 205. About Your System 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230

About Your System
39
This system
supports only
Opteron(TM) 2000
series
processors
Microprocessor(s) is not
supported by the system.
Install a supported
microprocessor or
microprocessor combination
(see "Installing a Processor"
on page 136).
Time-of-day
clock stopped
Faulty battery or faulty chip.
See "Troubleshooting the
System Battery" on page 170.
Time-of-day not
set - please run
SETUP program
Incorrect Time or Date
settings; faulty system
battery.
Check the Time and Date
settings (see "Entering the
System Setup Program" on
page 43). If the problem
persists, replace the system
battery (see "System Battery"
on page 138).
Timer chip
counter 2 failed
Faulty system board.
See "Getting Help" on
page 205.
TPM
configuration
operation
honored
System will now restart.
Information only.
TPM failure
A Trusted Platform Module
(TPM) function has failed.
See "Getting Help" on
page 205.
TPM operation is
pending. Press I
to Ignore or M to
Modify to allow
this change and
reset the system.
Configuration change has
been requested.
Press
I
to continue system
boot. Press
M
to modify the
TPM setting and restart.
Unexpected
interrupt in
protected mode
DIMMs are improperly
seated or the keyboard/mouse
controller chip has failed.
Reseat the DIMMs (see
"Troubleshooting System
Memory" on page 174). If the
problem persists, see
"Getting Help" on page 205.
Table 1-6.
System Messages
(continued)
Message
Causes
Corrective Actions