Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 140
properly. See Entering the System Setup Program on Exit the System Setup program.
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
b Hold the battery with the "+" facing up, and slide it under the securing tabs at the positive side of the connector. c Press the battery straight down into the connector until it snaps into place. See Figure 3-36. 8 Install the processor shroud. See "Installing the Processor Shroud" on page 74. 9 Install the expansion card shroud. See "Installing the Expansion Card Shroud" on page 75. 10 Close the system. See "Closing the System" on page 70. 11 Place the system upright and on its feet on a flat, stable surface. 12 Reattach any peripherals, then connect the system to the electrical outlet. 13 Turn on the system and attached peripherals. 14 Enter the System Setup program to confirm that the battery is operating properly. See "Entering the System Setup Program" on page 43. 15 Enter the correct time and date in the System Setup program's Time and Date fields. 16 Exit the System Setup program. 17 To test the newly installed battery, turn off the system and disconnect it from the electrical outlet for at least an hour. 18 After an hour, reconnect the system to its electrical outlet and turn it on. 19 Enter the System Setup program and if the time and date are still incorrect, see "Getting Help" on page 205 for instructions on obtaining technical assistance. 140 Installing System Components