Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 90
replacing. See Removing a Hot-plug Hard Drive on See
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
3 If you are replacing a hot-plug hard drive, remove the drive that you are replacing. See "Removing a Hot-plug Hard Drive" on page 88. If a replacement hard drive does not have the lever-release hard drive bracket attached, remove the bracket from the old drive and install it on the new drive. See Figure 3-14. The SAS/SATA hard-drive bracket has mounting holes to enable either a "SAS" or "SATA" mounting position, depending on your hard drive type. See Figure 3-14. Figure 3-14. Removing and Installing a Lever-release Hard Drive Bracket 2 3 4 1 1 mounting holes 3 drive bracket 2 screws (4) 4 hard drive 4 Install the hot-plug hard drive. a Open the handle on the hard-drive carrier. b Insert the hard-drive carrier into the drive bay until the carrier contacts the backplane. c Close the handle to lock the drive in place. 90 Installing System Components