Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 149
Remove the SAS/SATA backplane, Pull the backplane board until the securing slots are free from
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
4 Remove the expansion card shroud. See "Removing the Expansion Card Shroud" on page 72. 5 Remove the processor shroud. See "Removing the Processor Shroud" on page 72. 6 Open the drive-carrier release handle on each hard drive and partially extend the drive(s) out of their drive bays. See "Removing a Hot-plug Hard Drive" on page 88. 7 Disconnect the following cables from the backplane (see Figure 3-42): • SAS cable • Power cable • Backplane cable 8 Remove the SAS/SATA backplane: a Pull the blue backplane release pin. See Figure 3-42. b While pulling the release pin, slide the backplane to the left. c Pull the backplane board until the securing slots are free from the securing tabs, and lift the board from the chassis. Installing System Components 149