Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 151

3 Reconnect the following cables to the backplane (see Figure 3-42): • SAS cable • Power cable • Backplane cable 4 Reseat the hot-plug hard drives in the system. See "Installing a Hot-plug Hard Drive" on page 89. NOTE: Reinstall the hard drives in the same drive bays from which they were removed. 5 Install the processor shroud. See "Installing the Processor Shroud" on page 74. 6 Install the expansion card shroud. See "Installing the Expansion Card Shroud" on page 75. 7 Close the system. See "Closing the System" on page 70. 8 Place the system upright and on its feet on a flat, stable surface. 9 Install the front-drive bezel. See "Installing the Front Drive Bezel" on page 66. 10 Reattach any peripherals, then connect the system to the electrical outlet. 11 Turn on the system and attached peripherals. Control Panel (Service-only Procedure) Removing the Control Panel CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the system, and protecting against electrostatic discharge. 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2 Remove the front-drive bezel. See "Removing the Front Drive Bezel" on page 66. 3 Open the system. See "Opening the System" on page 68. Installing System Components 151