Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 81
Installing a Non-redundant Power Supply, Power Supply Distribution Board
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Installing a Non-redundant Power Supply 1 If you are installing a non-redundant power supply to replace redundant power supplies, you will need to replace the power supply distribution board with the power supply cage cover. a Remove the power supply distribution board. See "Removing the Power Supply Distribution Board" on page 143. b Install the power supply cage cover by pressing the cover into the power supply cage until the retention pins lock into place. See Figure 3-41. 2 Slide the power supply into the back of the system until the power supply release tab snaps into place. See Figure 3-8. 3 Install the two Phillips screws to secure the power supply to the system. See Figure 3-8. 4 Depending on your system configuration, connect the following power cables: • PWR1 connector on the system board • PWR2 connector on the system board • PWR3 connector on the system board • BP_PWR connector on the optional SAS/SATA backplane • Hard drives • Diskette drive • Tape backup unit • Optical drives 5 Install the processor shroud. See "Installing the Processor Shroud" on page 74. 6 Install the expansion card shroud. See "Installing the Expansion Card Shroud" on page 75. 7 Close the system. See "Closing the System" on page 70. 8 Place the system upright and on its feet on a flat, stable surface. 9 Reattach any peripherals, then connect the system to the electrical outlet. 10 Turn on the system and attached peripherals. Installing System Components 81