Dell PowerEdge T605 Hardware Owner's Manual (PDF) - Page 89
Installing a Hot-plug Hard Drive, Remove the front drive bezel, if attached. See Removing the Front
View all Dell PowerEdge T605 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
NOTICE: To maintain proper system cooling, all empty hard-drive bays must have drive blanks installed. Figure 3-13. Removing and Installing a Hot-plug Hard Drive 2 1 1 hard-drive carrier handle 2 lever-release drive bay Installing a Hot-plug Hard Drive NOTE: It is recommended that you use only drives that have been tested and approved for use with the SAS/SATA backplane. NOTICE: Not all operating systems support hot-plug drive installation. See the documentation supplied with your operating system. 1 Remove the front drive bezel, if attached. See "Removing the Front Drive Bezel" on page 66. 2 If a drive blank is present in the bay, remove it. See "Removing a Hot-plug Hard Drive Blank" on page 91. Installing System Components 89
Installing System Components
89
NOTICE:
To maintain proper system cooling, all empty hard-drive bays must have
drive blanks installed.
Figure 3-13.
Removing and Installing a Hot-plug Hard Drive
Installing a Hot-plug Hard Drive
NOTE:
It is recommended that you use only drives that have been tested and
approved for use with the SAS/SATA backplane.
NOTICE:
Not all operating systems support hot-plug drive installation. See the
documentation supplied with your operating system.
1
Remove the front drive bezel, if attached. See "Removing the Front
Drive Bezel
" on page 66
.
2
If a drive blank is present in the bay, remove it. See "Removing a Hot-plug
Hard Drive Blank" on page 91.
1
hard-drive carrier handle
2
lever-release drive bay
1
2