Yamaha DSP5D Owner's Manual - Page 121
Basic parametric EQ operations, Controlling the parametric EQ from the display, the display
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
6 Operate DCA faders 1-8. The corresponding frequency region will be boosted or cut. Hint If the fader of a graphic EQ is at the 0 dB position, the [NOMINAL] LED of the DCA fader will light. If it is at other than the 0 dB position, the DCA [MUTE] key will light. While the DCA [MUTE] key is lit, pressing the DCA [MUTE] key will reset the corresponding band to 0 dB. 7 If you want to use the DCA faders to control a different region, repeat steps 5-6. 8 When you have finished using the DCA faders to control the graphic EQ, either press the FADER MODE [DCA] key or click the OFF button in the ASSIGN TO FADERS area. When the [DCA] button is on, the FADER MODE keys and the DCA faders will return to their normal state. If you once again want to assign the graphic EQ to the DCA faders, either click a button in the ASSIGN TO FADERS area or hold down the [SHIFT] key and press a FADER MODE [A]-[F] key. Hint • GEQ module settings are saved as part of the scene. The settings of a GEQ module can also be saved in the GEQ library. For details, refer to GEQ LIBRARY screen (➥ p.174) in the Reference section. • When you switch the display to a different screen, the DCA fader assignments will be forcibly defeated, and will no longer function even if you return to the GEQ screen. However if you turn on the AUTO ASSIGN button in the GEQ PARAM screen, the DCA faders will automatically be assigned to the most recently operated region when you access the GEQ PARAM screen. Basic parametric EQ operations There are two ways to operate the parametric EQ: using the knobs and buttons in the display, or using the SELECTED CHANNEL section of the panel. Controlling the parametric EQ from the display Here's how to use the knobs and buttons of the GEQ PARAM screen (GEQ function) to operate the desired parametric EQ. 1 In the DISPLAY ACCESS section, repeatedly press the [GEQ] keys to access the GEQ PARAM screen. GEQ PARAM GEQ/PEQ button MODULE box EQ ON/OFF button 2 In the MODULE box, click the left/right / buttons to select the GEQ module that you want to operate. Make sure that the EQ ON/OFF button is on. Also make sure that the corresponding module is inserted into the appropriate channel, and that insert in/out is enabled for that channel. Hint An alternate way to select the desired GEQ module is to use the GEQ ASSIGN screen (GEQ function) (➥ p.173). 3 Click the PEQ button located in the upper middle of the screen to select the 8-band parametric EQ. 4 If you want to use the LOW band or HIGH band as a shelving-type EQ or as a high-pass or low-pass filter, click the / button of that band, or the HPF/LPF button to turn it on. If you switch to a shelving type, the Q knob will disappear. When you switch to a high-pass or low-pass filter, the Q knob will disappear, and the GAIN knob will change to the HPF/LPF on/off switch. 5 Using the Q knob, GAIN knob, and FREQ knob of each band, specify the steepness, gain, and center frequency for each band. The value of each setting is shown in the box below. Hint If you click the EQ FLAT button, the boost/cut amount of all bands will be reset to 0 dB. 15 Graphic EQ and Parametric PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section 121