Yamaha DSP5D Owner's Manual - Page 156
Selecting the buses used for cascade connection, connection
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
19 Other functions through which audio signals will be transmitted to and received from the cascade-connected external device. If "PM5D" or "DM2000/02R96" are selected as the other cascade-connected device, only "CASCADE IN" can be selected for the CASCADE IN PORT SELECT field. In the CASCADE OUT PORT SOURCE SELECT field, you can choose from the output channels of slots 1-4 as well as "CASCADE OUT" (➥ p.225). Hint If you choose a setting other than "CASCADE OUT" in the CASCADE OUT PORT SOURCE SELECT field, the same signal will be output from both the specified slot/channel and from the CASCADE OUT connector. Selecting the buses used for cascade connection Here we will explain how to select the buses used for the cascade connection, specify the items that will be linked, and enable the cascade connection. Perform the following steps on both the cascade master and cascade slave units. 1 In the DISPLAY ACCESS section, repeatedly press the [SYS/W.CLOCK] key until the CASCADE screen shown below appears. CASCADE ❏ Cascade slave (bi-directional cascade connections between PM5D units) 1 In the DISPLAY ACCESS section, repeatedly press the [SYS/W.CLOCK] key to access the MIXER SETUP screen. 2 In the CASCADE CONNECTION area located at the bottom of the screen, click the TYPE SELECT button to access the CASCADE TYPE SELECT window. 3 Select "PM5D - PM5D" as the connection type, and click the OK button to close the window. 4 In the CASCADE MODE area at the lower part of the screen, select "SLAVE". In addition, turn on the BI-DIRECTION button located immediately below it. 5 Select "PM5D" in the CASCADE FROM field and in the CASCADE TO field. 6 Make sure that "CASCADE IN" is selected in the CASCADE IN PORT SELECT field, and "CASCADE OUT" is selected in the CASCADE OUT PORT SOURCE SELECT field. In this combination you can enable/disable buses used for transmission/reception in the cascade connection, and select the operations that will be linked when multiple PM5D units are cascade-connected. Note In the case of a system that is cascade-connected to the DSP5D, the system will always operate as though the CASCADE LINK area's LINK button is on; this setting cannot be changed. 2 In the CASCADE LINK area at the left of the screen, turn on the buttons for the operations that you want to be linked. The settings of the CASCADE LINK area select the operations that will be linked when multiple PM5D units are cascade-connected. You can select the following items. • SCENE RECALL Scene recall operations / Recall undo operations 156 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section