Yamaha DSP5D Owner's Manual - Page 127
Using the MIDI Remote function, Assigning MIDI messages to controllers
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Hint • You can use the CLEAR button above the list to erase all assignments to control numbers. The PRESET button will return all control number assignments to their default state. • The contents of the control change table are not saved in the scene. If desired, you can save this data on a memory card as a MIDI CTRL TABLE. Using the MIDI Remote function "MIDI Remote" allows you to assign MIDI messages to the controllers (faders, encoders, CH [ON] keys, ENCODER [ON] keys) of the INPUT/ST IN channel strips so that these MIDI messages will be transmitted when you operate these controllers. This capability can be used for remote control of external MIDI devices such as synthesizers, or to control the parameters of DAW software or a HDR unit. While the MIDI Remote function is active, INPUT channel strip 1-24 functions as MIDI remote channels 1-24, and ST IN channel strip 1-4 functions as MIDI remote channels 25-28. Assigning MIDI messages to controllers Here's how to specify the MIDI port used by the MIDI Remote function, and assign a MIDI message to the desired MIDI remote channel. 1 In the DISPLAY ACCESS section, press the [MIDI/REMOTE] key several times to access the MIDI SETUP screen shown below. MIDI SETUP MIDI remote channels 1-24 MIDI remote channels 25-28 To each controller you can assign a MIDI message consisting of up to sixteen bytes of hexadecimal data. If desired, you can specify that a value within the message varies according to the movement of the controller. 2 In the MIDI REMOTE area at the right of the screen, select one of the following as the port from which MIDI messages will be output for each of the four MIDI Remote banks (BANK A- D). 16 Remote control MIDI USB SLOT 1-4 The rear panel MIDI OUT connector The rear panel USB connector An I/O card installed in rear panel slot 1-4 Click the / buttons at the left and right of each box to change the setting, and press the [ENTER] key (or click within the box) to finalize the setting. If you select USB or SLOT 1-4, use the box at the right to specify the port number (1-8) as well. PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section 127