Yamaha DSP5D Owner's Manual - Page 231
METER function, INPUT METER screen
![]() |
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
Information shown in the display • If the recall-source and recall-destination head amp devices have the same ID number but are assigned to different slots/ channels, the data will not be recalled to head amps of those ID numbers. • AD8HR data can be recalled into an AD824, and AD824 data can be recalled into an AD8HR. However when AD8HR data is recalled to an AD824, the gain settings of each channel will be converted into 6 dB units in order to match the specifications of the AD824. METER function INPUT METER screen This screen contains meters that show the input level of the input channels (input channels 1-48, ST IN channels 1-4, FXTRN channels 1-4). INPUT METER Function menu Global functions Output functions Input functions Appendices 12 3 A METERING POINT Select one of the following as the point at which the input level will be detected. This setting also applies to the meters on the panel. PRE ATT Immediately before the attenuator PRE GATE Immediately before the internal gate PRE FADER Immediately before the fader POST FADER . . . . . Immediately after the fader POST ON Immediately after the [ON] key B CH METER ALWAYS PRE ATT If this button is on, the input channel meters of the panel will always show the pre-attenuator levels. C PEAK HOLD If this button is on, the peak level of each meter will be held. When you turn this button off, the peak level indication that had been held will be cleared. Peak hold will be cleared when you change the metering point (1). This button is linked with the [PEAK HOLD] key in the METER section of the top panel. PM5D/PM5D-RH V2 / DSP5D Owner's Manual Reference section 231
![](/manual_guide/products/yamaha-dsp5d-owners-manual-81b84d8/231.png)