Yamaha DSP5D Owner's Manual - Page 22
DSP5D rear panel, Cooling fan vents, FAN switch, Mode switch, POWER LED, Grounding screw - update
![]() |
View all Yamaha DSP5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
2 Top, front, and rear panels DSP5D rear panel 1 5 FAN POWER HIGH LOW FAN POWER HIGH LOW 2 34 A Cooling fan vents These are the vents for the DSP5D's internal cooling fans (two locations). When placing the unit, take care that these vents are not obstructed. B FAN switch This switches the rotational speed of the DSP5D's internal cooling fans between HIGH and LOW. For normal use, set this to LOW. However if the DSP5D is in a location of high temperature or is outside in direct sunlight, set this to HIGH. You should also set this to HIGH if you feel that the panel is warmer than usual. C Mode switch This switch is used when initializing the settings of internal memory, when updating the firmware in the future, and when setting the machine ID number. D POWER LED This will light if power is being supplied to the DSP5D. E Grounding screw For safe operation, be sure that the DSP5D is correctly grounded. The included power cable has a three-pin plug, and if the AC outlet is grounded, the DSP5D will be grounded appropriately. If the AC outlet you're using is not grounded, you must be sure to connect this screw to a valid electrical ground. Correct grounding will effectively eliminate noises such as hum and interference. 22 PM5D/PM5D-RH V2 / DSP5D Owner's Manual Operating section
![](/manual_guide/products/yamaha-dsp5d-owners-manual-81b84d8/22.png)